Methods
Drugs and anaesthesia
The drugs and the anaesthesia of a report: a drug counts the whole container opened, and an anaesthetic agent its mass, from the fresh gas flow and the dial setting or a recorded volume, as emitted and as produced.
In short
- A drug counts the whole container opened, at 1.00 g/mL where no density is recorded.
- An agent's mass comes from a recorded volume, or from fresh gas flow, dial setting and minutes.
- The gases count as emitted, with the global warming potentials of IPCC AR6; their production is a separate line, with a factor for desflurane only.
- Drug and agent lines count under climate change only.
Methods of ClinImpact 2.21. Reports name the version they were computed with; the changelog says what changed.
Contents
What a drug costs#
A drug costs the whole container opened: the number of units opened in a procedure times the content of one unit as sold, converted to mass through the drug's density where the content is a volume. An opened ampoule is consumed whether the rest is given or discarded, and splitting one across patients is rare and mostly forbidden. The dose given is kept on the record and checked against the units opened.
A drug with no density recorded counts at 1.00 g/mL. Its line then says "density assumed 1.00 g/mL (none recorded)" and its data quality reads estimated. A drug whose content per unit is not recorded is shown and not counted.
The container's own glass, cap and stopper are costed through the item's components, and the container travels with its content from the manufacturer like any product (Transport). The drug's factor applies to the whole content as sold (the solution or emulsion); the active ingredient alone is not entered separately.
Volatile anaesthetic agents are metered by the vaporiser and costed as delivered. They are not items, so no transport is counted for them.
Anaesthetic gases#
Anaesthesia is recorded per procedure. Each recorded procedure has its own anaesthesia records, and the report adds them up, each counted once, in the same way as the disposables are summed over the procedures.
The project's template (the records without a procedure) is what each new procedure starts with. It is copied, with its materials and phases, into a procedure when the procedure is added, or into every procedure on request. The template itself is counted only on a project without procedures (one standard case, or a component study).
The report has one line per technique and agent, and per material, over all the procedures. Its trace gives the range when the procedures differ, and each procedure carries its own anaesthesia in the spread between procedures.
Mass of the agent#
A record may be entered in phases, at least wash-in / induction and maintenance, each with its own fresh gas flow, dial setting and minutes. The agent's mass is then the sum over the phases, and the record's duration their total. A record without phases uses its own flow, setting and duration.
| Agent | Recorded as | Mass |
|---|---|---|
| Volatile liquid (sevoflurane, isoflurane, desflurane) | a liquid volume in mL, or fresh gas flow × vaporiser setting × duration, per phase or for the whole record | volume × density; or Σ flow [L/min] × setting/100 × duration [min] → litres of vapour → ÷ vapour ratio → mL of liquid → × density → kg |
| Gas (nitrous oxide) | fresh gas flow × share of the fresh gas × duration, per phase or for the whole record | Σ flow × share/100 × duration → litres of gas → × gas density [g/L] → kg |
The vapour ratio (mL of vapour per mL of liquid) and the gas density are derived at 20 °C and 1 atm, molar volume 24.04 L/mol, from the agent's own stored density and its molar mass: sevoflurane 200.05 g/mol, isoflurane 184.49, desflurane 168.04, nitrous oxide 44.013. The derivation is written next to each value on the agent.
A recorded volume takes precedence over a derivation, since the volume is an observation and the derivation an estimate of it.
A liquid agent with no density recorded counts at 1.00 g/mL; its line says "density assumed 1.00 g/mL (none recorded)" and is rated estimated. The densities recorded are 1.52 g/mL for sevoflurane and 1.465 g/mL for desflurane.
An agent whose vapour ratio is missing can only be entered as a volume. A phase without its flow, setting or minutes leaves the mass unknown rather than smaller.
Emission#
The mass is multiplied by the exhaled fraction when the factor is per kg emitted (sevoflurane 0.95, isoflurane 0.998, desflurane 0.9998, nitrous oxide 1), then by the agent's GWP for the horizon the report is computed under:
| Agent | GWP 100 | GWP 20 |
|---|---|---|
| Sevoflurane | 195 | 702 |
| Isoflurane | 539 | 1930 |
| Desflurane | 2590 | 7020 |
| Nitrous oxide | 273 | 273 |
Source: IPCC (2021), AR6 WG1 Chapter 7 Supplementary Material, Table 7.SM.7, summarised for anaesthetic agents in Coburn et al., Eur J Anaesthesiol 2026;43:291-4. The same GWP 100 is applied under EF 3.1 Climate change and under IPCC 2021 GWP 100, and GWP 20 under IPCC 2021 GWP 20. Under any other indicator the agent line carries no figure and says so.
The exhaled fraction of sevoflurane, 0.95, is a conservative lower bound (5 % of the uptake is renally excreted; Anesth Analg 2025, doi:10.1213/ANE.0000000000007248; Eur J Anaesthesiol 2026;43:797-800). That of desflurane, 0.9998, reflects 0.02 % metabolised (Hu et al. 2021).
Production of the agents#
Each agent's production is a separate line beside its emission. It is the mass consumed (not only the exhaled share) × a production factor covering production and packaging, under GWP 100 or the GWP 20 scenario.
- For desflurane the factors are 304 and 702 kg CO₂ eq per kg (BJA Open 2025;16:100490, Table 1, after Hu et al., Resour Conserv Recycl 2021;167:105411).
- For sevoflurane the factor is 45.123 kg CO₂ eq per kg: synthesis route B in the 2026 corrigendum of Hu et al. (Resour Conserv Recycl 2026). It replaces the 224 of BJA Open 2025, which rests on the uncorrected 2021 figures. Route A gives 870.028; route B is probably the usual one, but that is not certain, so the Standard report shows the result with route A as a sensitivity case beside it. The corrigendum gives no GWP 20 figure, so the GWP 100 value is used under both horizons, as BJA Open 2025 Table 1 shows nearly equal values for sevoflurane (220 and 224).
- An administrator can change an agent's GWP values and production factors, for instance to follow another study; the report cites the source recorded with them. An alternative production factor, where one is recorded, is a sensitivity case only and never part of the result.
- Isoflurane and nitrous oxide have no production data.
Transport of the agents is not costed.
Materials, and what is not modelled#
The anaesthesia's own materials (tubing, glassware, soda lime) are costed as any component material, quantity × unit conversion × BAFU factor, summed over the procedures' records. An electricity dataset is re-pointed to the hospital's grid. Intravenous drugs given under the anaesthesia are ordinary drug lines (above), summed over the procedures and not multiplied again.
Scavenging or capture, oxygen and medical air, the machine's electricity and drug disposal are not modelled.